elmeg IP120 / en / elmegIP120_v1 / connectivity.fm / 01.08.2012
V
e
rsion 2, 27.0
5
.2010
59
elmeg IP120
Teldat
Configuring settings for the local network
LAN settings
You start network configuration via the display menu:
‰
¢
Settings
¢
Local Network
Selecting the network type
You may be asked to configure additional settings depending on your selection.
¢
below,
§§Back§§
Press the display key to return to the
Local Network
menu from where you select
the next network configuration step.
IPv4 configuration
§§Select§§
Press the display key to confirm the selection.
If the
Dynamic
setting is selected, all further settings are automatically configured. They are dis-
played and cannot be changed.
Please note:
To get access to network configuration you need to enter the administrator password. The
default setting is
admin
.
q
Select
Network Type
.
§§OK§§
Press the display key to confirm the
selection.
q
Select the IP protocol that is used in
your network (
IPv4
or
IPv6
).
§§Select§§
Press the display key to confirm the
selection.
q
Select
IP Address Type
.
§§OK§§
Press the display key to confirm the selec-
tion.
q
Select
Dynamic
if your device receives the
IP address via a DHCP server. Select
Static
if your device receives a fixed IP address.
If you have selected
Static
as the address type,
you must now create the following settings:
– IP Address
– Subnet Mask
–
Standard Gateway
–
Pref. DNS Server
and
– Altern. DNS Server
Network Type
Back
Select
IPv4
IPv6
IP Address Type
Back
Select
Static
Dynamic
Local Network
Back
OK
IP Address
Subnet Mask
Standard Gateway
