3.5 Connecting data
The Teldat Connect-4GE has the following data connections.
3.5.1 ETHERNET Connection
The Teldat Connect-4GE incorporates an Ethernet 10/100/1000 BaseT Switch port with automatic MDI/MDIX.
Fig. 12: ETHERNET Port
3.5.2 Connecting the WWAN Antenna
The Teldat Connect-4GE has three connectors to connect WWAN antennas. To assemble and disassemble the an-
tennas, simply screw them into the connectors on the router's front and side panels.
Installing these antennas in the Teldat Connect-4GE is essential when it comes to improving the quality of the signal
received and transmitted by the cellular model.
Note
To achieve good quality performance, the Teldat Connect-4GE should always have the WWAN anten-
nas installed.
Some cellular telephony technologies use the antenna diversity technique to improve the quality of the signal re-
ceived (HSUPA, CDMA EV-DO, LTE, etc.). As a result, the Teldat Connect-4GE router family incorporates various
WWAN connectors.
Fig. 13: The WWAN Antennas seen from the front panel
When the antennas are not directly connected to the router, but are installed through extension cords, the minimum
distance between the two must be 7cm. The maximum recommended distance between them is 25cm.
To achieve optimum performance, the radio frequency accessories installed (antennas and cables) should be those
recommended by Teldat.
Teldat has a series of available accessories (90º mount antennas, antennas for exterior installation, antennas for
ceiling installation, extension cables, etc.), which allow you to install the devices in different locations.
3 Components and Power Supply
Teldat S.A.
12
Teldat Connect-4GE Router