1.2.1 Power Source Connection
The Teldat C1+L router is powered with an external AC/DC source.
To avoid electric shocks, residual current circulation and other unwanted effects, also affecting communications, the
following is recommended:
Warning
All interconnected communication devices should be plugged to THE SAME GROUNDED POWER
OUTLET, which should at the same time be of good quality (lower than 10 ohms).
Whether the workplace is provided with an uninterrupted power supply system (UPS), regulated supply
or it is independent from the rest (such as lighting, etc.); it is highly recommended that all data devices
should be connected to the same power source. This will avoid operating and premature aging prob-
lems of drivers and other components.
Fig. 4:
Connecting the power with an external source
To connect the power source to the device, follow the steps listed in the earlier table: ensure that the switch is OFF
(0) and the power supply is NOT connected to the main electricity supply; find the 12 V DC connector, which is loc-
ated on the rear panel of the device, and plug it into the power source.
1.2.2 Data Connections
The Teldat C1+L router has the following available connectors:
1.2.2.1 4 port Ethernet Switch (connectors LAN1..4)
The Teldat C1+L router has a 410/100BaseT switch incorporated with an automatic MDI/MDIX to connect to the loc-
al area network (LAN).
Please pay close attention to the labeling. This is important in order to avoid mixing up the switch with other types of
ports.
1 Installing the Router
Teldat S.A.
4
Teldat C1+L Router
