TelcoBridges TSBC3000, Руководство по установке

Страница: 52 / 60

TSBC3000 Series Standalone and TSBC3000 Series 1+1 System Installation Guide
46
3.1 TSBC3000 Series SSH Connection
The TSBC300 series session border controller is shipped with the
T
ctrl software preinstalled. In order to
make changes to the system configuration, you must connect the port labeled MGMT0 or MGMT1 at
the rear of the unit to a terminal.
To access the TSBC300 series session border controller, you must use an SSH connection. The
password is set at the factory and is indicated on the shipment sheet.
Figure 3.1 TSBC300 Series Session Border Controller Management Interface
Note
See Section 3.5 on page 49 to learn how to change the IP address of the MGMT0 port.
3.2 TSBC3000 Series Serial Connection
3.2.1 Physical Connection
Two types of serial connection are possible:
• Section 3.2.1.1 “Connecting to the USB Port of the TSBC3000 Series”
• Section 3.2.1.2 “Connecting to the Serial Port of the TSBC3000 Series”
Mana g ement Interface
15 14 13 12
10 11 8 9 3 2 0
7 6 5 4
1
MGMT0
MGMT0
ETH0
ETH0
VOIP0
VOIP1
MGMT0
ETH VOIP
0 1 0 1
TMS
0 1
Mana g ement Interface
TSBC3000-680
TSBC3000-2700