TelcoBridges TMP6400, Руководство по установке

Страница: 41 / 58

Initial System Configuration
35
3.2 Using the set_boot and print_boot Commands
The set_boot command can be used to modify certain settings and the print_boot command can be
used to review the changes. Using the set_boot command, the System ID (also known as gateway port)
can be configured.
Settings will be applied on the next reboot of the platform.
Alternatively, you can use the default IP address of ETH1 or ETH2 to configure the Tmedia units, see
Section 3.5 “Tmedia Default IP Addresses” on page 40. To do this, connect a device on the same
subnet as the default IP addresses and connect using Telnet.
Note
System ID is also known as UDP gateway port .