INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following products:
MD02x / MD03x / ME04x / ME05x / ME06x
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this product is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
•
Allow 50mm above and around the fitting for air dissipation (do not cover the fitting with insulation)
•
This product is not for installation on flammable surfaces
•
This product is for indoor use only
•
This product is Class II double insulated
•
This product is IP20 rated
INSTALLATION
•
Provide power to the required point of installation
•
Cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1) ensuring not to
infringe with any joists, gas/water pipes or electrical cables
Fig. 1
Product code
Cut-out diameter (mm)
MD02x
80
MD03x
90
ME04x
90
ME05x
120
ME06x
140
•
Connect the luminaire to the mains supply using a suitable junction box (not supplied) ensuring the
correct polarity is observed: L - Live (brown),
N - Neutral (blue)
•
Lift both of the spring clips on the sides of the fitting and push into the ceiling (see Fig. 2)
INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following products:
MD02x / MD03x / ME04x / ME05x / ME06x
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this product is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
•
Allow 50mm above and around the fitting for air dissipation (do not cover the fitting with insulation)
•
This product is not for installation on flammable surfaces
•
This product is for indoor use only
•
This product is Class II double insulated
•
This product is IP20 rated
INSTALLATION
•
Provide power to the required point of installation
•
Cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1) ensuring not to
infringe with any joists, gas/water pipes or electrical cables
Fig. 1
Product code
Cut-out diameter (mm)
MD02x
80
MD03x
90
ME04x
90
ME05x
120
ME06x
140
•
Connect the luminaire to the mains supply using a suitable junction box (not supplied) ensuring the
correct polarity is observed: L - Live (brown),
N - Neutral (blue)
•
Lift both of the spring clips on the sides of the fitting and push into the ceiling (see Fig. 2)
Fig. 1
•
Connect the luminaire to the mains supply using a suitable junction box (not supplied) ensuring the correct
polarity is observed: L - Live (brown), N - Neutral (blue)
•
Lift both of the spring clips on the sides of the fitting and push into the ceiling (see Fig. 2)
