Telair TIG 3000D, Руководство по эксплуатации и инструкции по установке

Страница: 22 / 48

TIG 3000 D
Vers. 002
22
GB
8.9.3 Low output voltage
the output
voltage has dropped too far below the minimum
limit, probably due to poor performance of the in-
ternal combustion engine or to a single very high
load being applied without the use of the BOOST
function, the generator stops, the red alarm LED
lights up (Fig. 30 ref. 8).
8.9.4 Oil pressure
insufficient
engine oil lubricant level or pressure has been
detected, the generator immediately stops and
the red alarm LED lights up.
8.9.5 Engine temperature too high
an exces-
sive engine temperature has been detected, the
generator immediately stops and the red alarm
LED lights up.
8.9.6 Data communications error
this message indicates that
there has been an error in communication be-
tween the control panel and the control board on
the generator. Check the connection. Obviously
this alarm cannot be cancelled merely by press-
ing the START/STOP button.
8.9.7 Error codes
Open the menu (as indicated in another part of
the manual) until the following text appears
By pressing BOOST and then START/STOP or
AUTO, the error codes of the last 10 recorded
alarm events can be viewed. This is the list of the
main alarm codes:
1 Start-up failed
2 Battery voltage too low
3 Motor over-revving
4 Oil level or pressure
5 Motor over-heating
9 Data connection to inverter lost
50 Short circuit on inverter output
51 Overload on inverter output
52 Inverter voltage too low
53 Inverter over-heating
57 An inverter input phase is missing
59 Inverter continuous voltage too high
8.10 Warning messages and causes
8.10.1 Check engine oil level
this message appears alter-
nately with the normal messages on the display
and is highlighted by the illumination of the red
LED (Fig. 30 ref. 7); it calls for the oil level to be
checked (and topped up if necessary).
Once the check has been completed, reset the
corresponding hour counter:
press the MENU button and the following mes-
sage will appear
Press the MENU button again to confirm reset-
ting of the hour counter. The following message
will appear
the red LED switches off (Fig. 30 ref. 7) and the
related message disappears from the display.
8.10.2 Engine oil replacement
this message appears alter-
nately with the normal messages on the display
and is highlighted by the illumination of the red
LED (Fig.30 ref.7); it calls for the engine oil to be
changed.
After completing the operation reset the corre-
sponding hour counter:
press the MENU button and the following mes-
sage will appear