Telair Silent 7300H, Инструкция по установке и эксплуатации

Страница: 13 / 24

13
GB
5.5 Information on the Remote Control
•
Point the remote control towards the
internal unit of the conditioner.
•
There must be no obstructions between
the remote control and the internal unit.
•
Do not drop or throw the remote control.
•
Do not expose the remote control to direct
sunlight or leave it near heating systems
or other sources of heat.
•
Use two AAA batteries.
•
If you do not intend to use the remote
control for some time, remove the
batteries.
•
When the signal transmission noise is no
longer audible inside the unit or when the
transmission symbol on the display
screen is no longer clearly visible, the
batteries need replacing.
•
If the unit resets when a control key is
pressed battery power is too low: change
the batteries.
5.6 Remote control key definitions/
functions
On/Off
Press this key to start the air
conditioner; press it again to switch it off.
Mode
Allows the user to select the working
mode: each touch of the key changes the
mode.
The display shows the following:
Display
Shows working mode and the fan
speed setting (fig. 19)
Temperature increase
Press this key to
increase the temperature setting
Temperature decrease
Press this key to
lower the temperature setting
Fan speed
Allows the user to select one of
the three available fan speeds.
When the air conditioner
is switched on 3 minutes will pass before
the compressor is started and cold/hot air
begins to flow from the diffuser.
Wait at least 2 minutes
between switching off and subsequent
switching on so as not to damage the
compressor.