Tektronix WFM8200, Руководство по обслуживанию

Страница: 64 / 85

Removal and Replacement Procedures
required to remove and reinstall the modules is listed in the following table. (See
Table 4-8 on page 4-24.)
Table 4-8: Tools required for module removal
Item
no.
Name Description
General Tool
number
1 Screwdriver handle Accepts Torx-driver bits 620-440
2 T-10 Torx tip Used for removing most instrument
screws. Torx-driver bit for T-10 size
screw heads 640-235
3 T-15 Torx tip Used for removing instrument
screws. Torx-driver bit for T-15 size
screw heads 640-247
4 1/8 inch fl at-bladed
screwdriver
Screwdriver for unlocking cable
connectors Standard tool
5 Angle-Tip Tweezers Used to remove front panel knobs Standard tool
6
3
/
16
inch nut driver Used to remove jack screws and
front panel standoffs Standard tool
7
5
/
16
inch nut driver Used to remove nut on AC ground
lug Standard tool
8 MA-800G Soldering Aid
(spudger) Used to remove the front panel trim Standard tool
9 Bomar DB36400 Special BNC socket wrench with
Controlled Torque. Used to remove
Audio board BNCs
– – – – –
10 Soldering iron (15 W) Used for replacing Main board
fuses Standard tool
11 Long nose pliers Used to compress connector lock
tabs Standard tool
4–24 WFM8200 and WFM8300 Waveform Monitors Service Manual