Installation instructions
RM2 installation
Use the following procedure and refer to the illustrations to assemble the RM2
(two instruments) rackmount hardware and install the instruments into the rack.
(See Figure 4.) (See Figure 5.)
CAUTION.
You must remove the feet from the bottom of each instrument if you
intend to install them immediately above other instruments in the rack (with no
clearance). To so this, you will need to use a
fl
at-bladed screwdriver to pry out the
7/16"–deep plugs that cover the hidden screws, and then use a Torx T20 driver to
loosen the screws to remove the feet.
Figure 4: RM2 assembly part 1
TSG4100A Series RM1 and RM2 Rackmount Kit Instructions
7
