Tektronix TG700, Руководство пользователя

Страница: 73 / 343

Operating Basics
Install the jumper on pins 3+4 of J452 (factory-default position) to set the clock
output level to CMOS compatible. Install the jumper on pins 1+2 of J452 to set
the clock output level to 1V.
Figure 2-4: Location of J452 on the AG7 module
AGL7 Module Connectors The AGL7 Analog Genlock module is equipped with six BNC connectors as
described below. (See Figure 2-5.)
Figure 2-5: AGL7 module connectors
REF : Input loopthrough connectors for an external reference signal, which
can be NTSC/PAL black burst or HDTV trilevel sync signals. The signal
input requires proper external termination.
CW : Internally terminated input connector for CW (Continuous Wave)
signals: 1, 3.58, 4.43, 5, and 10 MHz.
You can con fi gure the CW connector to output a 48 kHz word clock signal.
(See page 2-6, Changing the Input/Output Con fi guration .)
BLACK 1: Outputs the selected black burst signal.
NOTE. You cannot output HDTV trilevel sync signals from the BLACK 1
connector.
TG700 TV Signal Generator Platform User Manual 2–5