Operate the current probe
Degauss and autobalance the current probe
Degauss the probe to remove any residual magnetization from the probe core.
Such residual magnetization can induce measurement error. Autobalancing
removes unwanted DC offsets in the ampli
fi
er circuitry. Failure to degauss the
probe is a leading cause of measurement errors. The DEGAUSS LED
fl
ashes
until you degauss the probe.
To degauss the probe, disconnect the probe from the test circuit, or ensure that
the conductor under test has no power, close and lock the slide, and then press
the ampli
fi
er PROBE DEGAUSS AUTOBALANCE button on the front panel of
the ampli
fi
er. To maintain measurement accuracy, degauss your probe in each of
these cases:
After you turn on the ampli
fi
er and allow a 20-minute warm-up period.
Before you connect the probe to a conductor.
Whenever a current or thermal overload condition occurs.
Whenever you connect a new probe.
Whenever you subject the probe to a strong external magnetic
fi
eld.
Periodically during normal use.
To degauss and autobalance a current probe, perform these steps:
1.
Verify that the current probe is connected to the ampli
fi
er.
2.
Remove the current probe from the conductor under test.
3.
Lock the probe slide closed.
4.
Press the ampli
fi
er PROBE DEGAUSS AUTOBALANCE button.
5.
Wait about
fi
ve seconds for the degauss procedure to complete.
The
PROBE DEGAUSS AUTOBALANCE
LED glows green when the
operation has successfully completed. If the LED is blinking orange, the degauss
operation is still in progress. If the LED is red, the operation failed, and the cause
of the failure needs to be found and
fi
xed. (See page 17,
Operate the ampli
fi
er
.)
NOTE.
The degauss procedure will fail if the ampli
fi
er is not properly connected
to an oscilloscope having 50
Ω
input impedance. If this occurs, the NOT
TERMINATED INTO 50
Ω
LED lights on the ampli
fi
er front panel.
After you have completed the oscilloscope adjustments and the ampli
fi
er
degauss/autobalance procedure, your system is ready to measure current.
24
Ampli
fi
ers and Current Probes Compliance and Safety Instructions
