Tektronix MSO54, Руководство программиста

Страница: 807 / 1026

Commands listed in alphabetical order
Conditions Requires the SR-ENET Triggering and Analysis application.
Group Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:DESTinationport:
VALue <QString>
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:DESTinationport:
VALue?
Related Commands TRIGger:{A|B}:BUS:B<x>:ETHERnet:CONDition
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:ACKnum:VALue
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:SOUrceport:VALue
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:SEQnum:VALue
Arguments
<QString>
is a quoted string of up to 16 characters where the allowable
characters are 0, 1, and X. The bits speci fi ed in the quoted string replace the least
signi fi cant bits, leaving any unspeci fi ed upper bits unchanged.
Examples
TRIGger:A:BUS:B1:ETHERnet:TCPHeader:DESTinationport:VALue
"XXXXXXXX00100010"
would set the destination port address value that is to be
used in the trigger to hexadecimal
XX22
.
TRIGger:A:BUS:B1:ETHERnet:TCPHeader:DESTinationport:VALue?
might return
"XXXXXXXXXXXXXXXX"
.
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:SEQnum:VALue
When the Ethernet trigger condition is set to
TCPHeader
, this command speci fi es
the 32–bit sequence number that is to be used in the trigger (along with the
destination and source port addresses and the acknowledgement value). The
default is all X’s (don’t care). The bus number is speci
fi ed by <x>.
Conditions
Requires the SR-ENET Triggering and Analysis application.
Group Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:SEQnum:VALue
<QString>
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:SEQnum:VALue?
MSO54, MSO56, MSO58, MSO58LP Programmer 2-791