Four-wire remote sense connection
You can use four-wire remote sense connections for higher
measurement precision.
To connect the DUT to the load using a four-wire remote
sense connection:
1
Unscrew the two nuts and remove the two protective covers.
2
Connect the cables to the two input terminals.
3
Mount the protective covers to the two input terminals.
4
Screw the two input terminals tight.
5
Connect the other end of the cables to the DUT. The red cable is
connected to the positive electrode and the black cable is
connected to the negative electrode.
6
Connect the DUT to the remote sense terminals on the rear
panels, as shown in the next wiring diagram.
Steps1 through 5 above are the same as the steps for two-wire
connection. For the illustrations of the steps, see
Two-wire
connection
.
北京海洋兴业科技股份有限公司（证券代码：839145）
www.hyxyyq.com
