Tektronix B MSO 6 Series, Руководство пользователя

Страница: 20 / 47

4. Use a screwdriver with T-10 Torx tip to remove the four screws from each foot assembly.
5. Remove the feet assembles.
6. To reinstall, reverse the steps. Use a screwdriver with T-10 Torx tip to secure the eight screws. First insert and tighten
the screws that are near the front edge of the instrument, then insert and tighten the screws that are near the rear edge
of the instrument. Tighten to 0.65 N·m.
Remove handle
Use this procedure to remove and replace the handle assemblies.
Before you begin
Prerequisite:
• To prevent electrostatic damage to components whenever you work on the instrument, wear properly-grounded
electrostatic prevention wrist and foot straps, and work in a tested antistatic environment on an antistatic mat.
About this task
Steps:
About this task
Remove the handle assemblies using the following steps:
Procedure
1. Use a screwdriver with T-10 Torx tip to remove two screws from each side of the handle.
2. Disengage the handle from the pins on the couplers and remove the handle.
3. Remove the two couplers.
4. To reinstall, reverse the steps. Use a screwdriver with T-10 Torx tip to secure the screws. Tighten to 0.65 N·m.
Remove rear grill and case
Use this procedure to remove and replace the rear grill and rear case.
Before you begin
Prerequisites:
• To prevent electrostatic damage to components whenever you work on the instrument, wear properly-grounded
electrostatic prevention wrist and foot straps, and work in a tested antistatic environment on an antistatic mat.
•
Remove handle
on page 10.
• Remove feet on page 9.
• Remove hard drive door.
About this task
Steps:
About this task
Remove the grill and rear case using the following steps:
Procedure
1. Use a screwdriver with T-8 Torx tip to remove the six screws securing the grill to the rear case .
2. Put fingers in handle hub holes on each side of the grill and pull the grill off of the rear case.
3. Use a screwdriver with T-10 Torx tip to remove the six screws securing the rear case to the rear chassis .
4. Slide the rear case off of the rear chassis.
Maintenance
6 Series B MSO MSO64B, MSO66B, MSO68B Service 10