Tektronix AWG7 1B Series, Руководство по обслуживанию

Страница: 59 / 174

Maintenance
Inspect the internal portions of the instrument for damage and wear, using the
following table as a guide. Defects should be repaired immediately.
CAUTION.
To prevent damage from electrical arcing, ensure that circuit boards
and components are dry before applying power to the instrument.
Table 4-2: Internal inspection checklist
Item Inspect for Repair action
Front and Rear
Case Cracks or deformations. Scratched
lettering or display
fi lter. Loose
connectors or labels.
Repair or replace
defective hardware.
Circuit boards Loose, broken, or corroded solder
connections. Burned circuit boards.
Burned, broken, or cracked circuit-run
plating. Remove failed module
and replace with a new
module.
Solder connections Cold solder or rosin joints. Resolder joint and clean
with ethyl alcohol.
Wiring and cables Loose plugs or connectors. Burned,
broken, or frayed wiring. Firmly seat connectors.
Repair or replace
modules with defective
wires or cables.
Chassis Dents, deformations, and damaged
hardware. Straighten, repair,
or replace defective
hardware.
Cleaning Procedure – Interior. Do the following steps to clean the instrument
interior:
1. Blow off dust with dry, low-pressure, deionized air (approximately 9 psi).
2. Remove any remaining dust with a lint-free cloth dampened in isopropyl
alcohol (75% solution) and rinse with warm deionized water. (A cotton-tipped
applicator is useful for cleaning in narrow spaces and on circuit boards.)
NOTE.
If steps 1 and 2 do not remove all the dust or dirt, please contact Tektronix.
(See Contacting Tektronix at the front of this manual.)
Lubrication.
There is no periodic lubrication required for the instrument.
AWG7000B and AWG7000C Series Service Manual 4–5