Tektronix 7M13, Инструкция по эксплуатации

Страница: 7 / 34

Operating
Instructions-7M13
OPERATION
The 7M13 Readout Unit will operate in any plug-in
compartment
of a Tektronix 7000-series
oscilloscope equipped with a readout system. The 7M13 Readout Unit is activated by pressing it firmly into
position in
a
compartment of the oscilloscope mainframe. The display will appear on the CRT in the
position associated with the selected plug·in slot.
Channel Selection
The WRITE pushbuttons provide channel selection.
Channel
1 is
selected
by pressing the UPPER
pushbutton and channel 2 by pressing the LOWER pushbutton. These pushbuttons illuminate (in
compatible mainframes) to indicate the position selected.
Erase
The ERASE pushbutton must
be
pressed before entering data for display. This clears
the
selected
channel of any previously entered
data
and resets the 7M13 circuits to accept new data. The ERASE
pushbutton does not affect the camera counter display.
Data Display
Both channels have
a
d i
s
pl a y capacity of
ten characters
or sp
a
ce s .
Each character,
induding the decimal
point, requires one space in the display.
Each ch a ra cter pushbutton switch is labeled with the character it selects. Pressing any of these switches
causes
its
associated character
to be
d
i s
p
l a
y
ed
on the CRT. Spacing between characters or words is provided
by the SPACE pushbutton. Pressing this switch causes the display to skip one space.
Subsequent pressing of
a character
switch when all ten display spaces are filled will cause the tenth space
character to be replaced with the newly selected one.
Modify
The
M O
D I F Y
pushbutton allows the last entered character to
be changed
without
erasing
the display.
This switch must be pressed and held while the new character switch is pressed. The last entered character
will then be rep
l ac ed
with the newly entered one.
Camera Counter Operation
The CAMERA COUNTER is
activated
by pressing the PUSH ON switch. The switch locks in and
illuminates when the CAMERA COUNTER is selected. This causes the 2-digit camera count to be displayed
in channel 2.
The camera counter display is set to zero by pressing the (P)RESET switch.
Once
this is done,
two
zeros
will appear in the display as the camera count. If it is desired to set the
camera
count to some number other
than zero, the (PIRESET switch must be pressed and held while the desired number is entered. When
presetting the CAMERA COUNTER, the first number pressed will be entered
as
the tens digit and the
second
as
the units digit.
1-2