Tektronix 5110, Инструкция по эксплуатации

Страница: 36 / 128

Adjustment-5110
Table 3-1 (cont)
LIST OF TEST EQUIPMENT REQUIREMENTS FOR ADJUSTMENT
Description
Performance
Requirements
Application Example
Coaxial cable
Impedance, 50 Ω, length,
18 inch; connectors, bnc.
Step 13. a. TEKTRONIX part
012-0076-00.
Termination Impedance, 50 Ω; accuracy,
within
2%, connectors, bnc.
Step 13. a. TEKTRONIX part
011-0049-01.
Tee connector Connectors, bnc. Step 13. a. TEKTRONIX part
103-0030-00.
Insulated Screwdriver
Length, 1 1/2-inch shaft
or longer; plastic shaft
and handle with metal
screwdriver tip.
Recommended for
all adjustments.
a. TEKTRONIX part
003-0000-00.
PRELIMINARY PROCEDURE FOR
ADJUSTMENT
NOTE
The oscilloscope must be adjusted within an am­
bient temperature range of +20° C to +30° C for best
overall accuracy and to meet the electrical
characteristic tolerances given as Performance Re­
quirements in the Specification section of this
manual. Information given as Supplemental Infor­
mation in the Specification section is provided for
user information only, and should not be interpreted
as Performance Requirements.
1. Remove the cabinet sides and bottom from the
oscilloscope (refer to Cabinet Removal in the
Maintenance section of this manual).
2. Check the rear panel of the oscilloscope to ensure
that the indicated line voltage and the line voltage source
are
the same (refer to Operating Voltage in the
Maintenance section of this manual).
3. Ensure that all test equipment is suitably adapted to
the line voltage to be applied.
4. If applicable, install the TM 500-series test equip­
ment into the test equipment power module.
5. Install a vertical amplifier unit into the left vertical
compartment of the oscilloscope.
6. Install a time-base unit into the horizontal compart­
ment of the oscilloscope.
7. Connect the equipment under test and the test
equipment to a suitable line voltage source. Turn all
equipment on and allow at least 20 minutes for the
equipment to stabilize.
NOTE
Titles for external controls of the oscilloscope are
capitalized in this procedure (e.g. INTENSITY,
POWER). Internal adjustments are initial capitalized
only (e.g. Intensity Range, Vertical Gain).
Initial Control Settings
Set the following controls during warm-up time:
OSCILLOSCOPE
INTENSITY, FOCUS Set for well defined trace and
normal brightness.
AMPLIFIER PLUG-IN
Display On
Position
Centered
Voits/Div
1
Volts/Div Cal
Fully clockwise
Input coupling de
3-2