Tektronix 5110, Инструкция по эксплуатации

Страница: 25 / 128

Specification and Performance Check-5110
Table 2-4 (coni)
DISPLAY
Characteristics
Performance
Requirements
Supplemental
Information
Accelerating Voltage
3.5 kV.
Orthogonality
90°, within 1°.
Geometry
0.1 division or less.
Beam Finder
Limits display to within
graticule area and
intensifies display if
brightness level is low.
Table 2-5
CALIBRATOR AND POWER INPUT
Characteristics
Performance
Requirements
Supplemental
Information
Calibrator
Voltage
400 mV, within 1%.
Current
4 mA, within 1%.
Frequency
Twice the line frequency.
Power Input
Line Voltage (RMS)
Nominal 100 V, 110 V, 120 V, 200 V,
220 V, 240 V ±10% (250 V maximum).
Fuse Data
1.6 A slow blow (120 V ac).
1 A slow blow (240 V ac).
Line Frequency
48 to 440 Hz.
Power Consumption
Typical: 53 W. Maximum: 75 W.
Insulation Voltage
1500 V (RMS) minimum at 50 to 60 Hz
for 10 seconds duration minimum.
Ground Continuity (Between
Safety Ground and Instrument) Less than 0.1 Ω.
ENVIRONMENTAL CHARACTERISTICS
Table 2-6
ENVIRONMENTAL
Characteristics Performance Requirements Supplemental Information
Temperature
Operating
0°Cto+50°C.
Storage
-40° C to +70° C.
Altitude
Operating
To 15,000 feet.
Storage To 50,000 feet.
Vibration
Operating and
Non-Operating
With the instrument complete and oper­
ating, vibration frequency swept from
10 to 50 to 10 Hz at 1 minute per
sweep. Vibrate 15 minutes in each of
the three axes at 0.015" total dis­
placement. Hold 3 minutes at any
resonance, or if none, at 50 Hz.
Total time, 54 minutes.
REV
B, NOV 1978
2-3