Tektronix 1235N - Phaser Color Laser Printer, Руководство по обслуживанию

Страница: 60 / 240

46
Phaser 1235 Network Color Printer
Other problems
These problems may be indicated as errors on the front panel.
The printer continuously displays “Booting” or “Initializing.”
The most likely cause is that the system controller board has not successfully
loaded its EEPROM contents (instructions) into RAM. The health indicator LED
(heart beat) usually indicates such an error state by being on or off but not
flashing. All print engine operation halts, and will only become ready when the
system controller board successfully boots.
1. Re-powering the printer, or perform a NVRAM reset can may fix this
problem.
2.
To verify if the system controller board has failed:
a.
Power down the printer, and remove the system controller board
board.
b. Power-up the printer. Wait at least 5 minutes while the print engine
initializes. If there was a problem with the system controller board,
it will now not affect the print engine controller board.
c.
If the print engine powers up correctly, a traveling “
*
” moves
around the control panel display. If not, then your problem is most
likely associated with the print engine controller board, and you
will need to replace it. If, however, you see the traveling “
*
”, then
the most likely cause is the system controller board.
False “No toner cartridge installed” message
1.
Ensure that the toner cartridge is correctly installed.
2.
Replace the toner cartridge.
3. Test the toner cartridge sensor board using the service test “Switch scan
test” on page 63.
4.
Replace the engine controller board.
False “No fuser unit installed” message
1.
Ensure that the fuser unit is correctly installed.
2.
Check the condition of fuser units’s connector and their corresponding
receptacles on the print engine (under the fuser unit).
3. Replace the fuser unit.
4. Replace the engine controller board.
5.
Replace the low-voltage power supply.