Maintenance—P6047
5.
Unsolder the parallel resistor and capacitor
from the
cable
assembly,
again
using
a heat
sink.
6. Install
the new cable assembly by reversing
the
above
procedure.
7.
After the probe
is
re-assembled, compen-
sate as described
in
Section
2. Then
compensate
for high frequencies according to the procedure
given
in
Section
4.
Replacing Components
To
replace any electrical parts
in
either the
compensating box or the probe tip you
will
need
a phillips head screwdriver, a pair of long-nose
pliers, and a soldering
iron.
Avoid excessive heat and
repeated
soldering
on the circuit
board
to preserve the bond be-
tween the conducting material and the board.
Probe
Body
and Sleeve
Fig.
3-2. Probe Assembly, 6-foot Cable.
3-2
