User Manual
T0004280_UM
Version 1.4
TEKTELIC Communications Inc.
Confidential
Page 7 of 8
Compliance Statements
Federal Communications Commission
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received,
including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
To comply with FCC/IC RF exposure limits for general population /
uncontrolled exposure, the antenna(s) used for this transmitter
must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
Industry Canada
This Device complies with Industry Canada License-exempt RSS
standard(s). This digital apparatus does not exceed the Class B
limits for radio-noise emissions from digital apparatus as set out
in the Radio Interference Regulations of the Canadian
Department of Communications ICES-003(B)
.
Operation is
subject to the following two conditions:
1.
This device may not cause interference, and
2.
This device must accept any interference, including
interference that may cause undesired operation of the
device.
This radio transmitter 22504-T0004280 has been approved by
Industry Canada to operate with the antenna listed below with
the maximum permissible gain or lesser and required antenna
impedance for the antenna indicated. Antenna types not
included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this
device.
This device complies with IC radiation exposure limits set forth
for an uncontrolled environment. This device should be installed
and operated with minimum distance 20cm between the radiator
and your body.
This device has been designed to operate with the antenna listed
below, and having a maximum gain of 2.7 dBi. Antennas not
included in this list or having a gain greater than 2.7 dBi are
strictly prohibited for use with this device. The required antenna
impedance is 50 ohms.
ET830DBLTRPSMA – Airgain, Inc.