Kona Micro User Guide
T0005281_UG
Version 1.2
TEKTELIC Communications Inc.
Confidential
Page 13 of 29
Figure 6: Battery Installation
2.6.
RF Cable Installation
The Kona Micro Gateway installation requires connection to a LoRa RF antenna. The antenna
attaches to the reverse SMA connector located on the side of the Gateway. Torque the connector
to 5 in·lbs. The Kona Micro is not protected from lighting surge as it is intended for Indoor use.
Do not connect to an outdoor antenna.
Note that the 3G/4G modem antenna is internal to the Kona Micro Gateway.
2.7.
Copper Ethernet Cable Installation
The Kona Micro Gateway Ethernet port may be used on a temporary basis for commissioning and
maintenance or may be permanently connected for backhaul.
The Ethernet cable must have minimum 24 AWG conductors and shall be rated for indoor
application according to local and national electrical codes.
2.8.
Proposition 65 Statement
⚠
WARNING: This product can expose you to chemicals including lead, beryllium, cobalt
oxide, nickel oxide, carbon black and lithium nickelate & nickel, which is known to the State of
California to cause cancer, birth defects or other reproductive harm. For more information, go
to
