2
Rev. LAN-
РАС-v1_5_en
5.3.2 Installing the module in the Control Panel 812 Pro :
1)
Turn off the power of the Control Panel 812 Pro.
2)
Remove the base of
the Control Panel 812
Pro by unscrewing the 4
screws from the side of
the base.
3)
Install the terminal
block board from the de-
livery set and the module
itself on the PCB 812
Pro from the side of the
base.
4)
Install the base
5)
Open
the
keypad
cover of the Control
Panel 812 Pro
6)
Remove the terminal
compartment cover by
unscrewing the 2 screws
securing it.
7)
Pass the network interface wires through the wire entry
hole, ensure hidden wiring to the terminals of the Control Panel
812 Pro is carried out in accordance with section 7 (table 2).
8)
Replace the cover of the terminal compartment, tighten the
two screws. Close the keypad cover if necessary.
6 SETUP
Module configuration is carried out using a computer and the
PKM program Astra-Pro according to the method described in
the User's Manual of the software.
When using the module as part of the Astra-812 Pro control
panel, it is possible to add and configure it through the built-in
keypad and display of the Astra-812 Pro control panel accord-
ing to the instructions for the Astra-812 Pro control panel.
7 CONNECTION TO THE NETWORK
The control panel PCB contains screw terminals for connecting to
the Ethernet network (connection to the control panel 812 Pro is
made through the terminals of the installed terminal board).
Terminals functions
is presented in
Tables 1, 2:
Table 1
– Control Panel 8945 Pro
CP terminals
Terminals function
Terminals are used when installing the
module in slot A:
A1
- to connect Tx-;
A2
- to connect Tx+;
A3
- to connect Rx-;
A4
- to connect Rx+.
Terminals are used when installing the
module in slot B:
B1
- to connect Tx-;
B2
- to connect Tx+;
B3
- to connect Rx-;
B4
- to connect Rx+.
Table 2 - Control Panel 812 Pro
Control Panel
terminals
Terminals function
A1
- to connect Tx-;
A2
- to connect Tx+;
A3
- to connect Rx-;
A4
- to connect Rx+.
Network connection must be provided with a
TIA/EIA-568-B
crossover type network cable.
The connection diagram is shown in the figure
:
If module is installed into slot A of the Control Panel 8945 Pro,
or into the Control Panel Astra-812 Pro slot:
when installed into slot
B
of the 8945 Pro Control Panel
9
WARRANTY
9.1 Warranty period of operation - 2 years from the date of
commissioning, but not more than 2 years 6 months from the
date of manufacture.
9.2 Average module life is 10 years.
9.3
The warranty does not take effect in the following
cases
:
–
non-observance of this user guide;
–
mechanical damage to the module;
–
module repair by a person other than the manufacturer.
9.4 The warranty only applies to the module. All third party
equipment used with the module is covered by their own war-
ranties.
The manufacturer is not liable for any damage to health,
property, or other incidental or special loss, direct or indi-
rect damages based on the user's claim that the module
did not fulfill its functions, or as a result of misuse, failure
or temporary inoperability of the module.
Manufacturer:
ZAO NTC TEKO
420108, Russia, Kazan,
Gafuri str., 71
Tel.:+7 843 528-03-69
Made in Russia