Teknoware TAPSA CONTROL TKT65, Инструкция по установке и обслуживанию

Страница: 23 / 53

VOT 34; Rev 1.81; EN; 11.12.2019
TKT65C
– Installation and maintenance
23
Or, while connecting maintained luminaires without Control function
and K model luminaires to a same circuit
“Mode” link open
Non-maintained emergency luminaire circuit
As factory setting, all circuits are connected as maintained (exit luminaire or Local Controller). If you
wish to change into non-maintained emergency luminaire circuits, the "Mode" link needs to be removed
from those circuits. Layout for “Mode” links is in next chapter.
NOTE! If you have control type luminaires (model type ends with letter K) or address modules with
maintained/non-maintained selection, all mode links can be closed. Luminaire will be selected
maintained or non-maintained with DIP
–switch. See further information from luminaire’s operation
manual.
1. Connect the alarms and the remote control switch into the connectors shown in APPENDIX 4:
Circuit diagram with BCM connection
2. Set the system date on time so that the automatic tests can take place when scheduled (factory
setting at 00.00 o’clock)
Parts layout
TKT65..CP (Cabinet construction):