Tekno RC NB48.4, Инструкция по сборке

Страница: 20 / 32

20
Shock Filling Instructions
For both front and rear shocks
Step 1. Insert all four larger o-rings into the emulsion caps and set aside. Install the small o-rings onto the
small emulsion screws by placing the o-rings on a pit mat or towel and pressing the screws into the o-rings.
Step 2. Fill shock with oil all the way to the top and pump the shock shaft up and down 3-5 times.
Step 3. Screw on the cap all the way tight (shock tool TKR1115 is helpful in tightening completely).
Step 4. With the shock at about a 45° angle, push and hold the shock shaft to the top and insert the
prepared emulsion screw/seal. Oil will leak out during this process. Tighten the screw until snug
(do not overtighten).
Step 5. Pump the shock shaft up and down about 30 times vigorously. This emulsifies the oil.
Step 6. With the shock shaft fully extended, remove the emulsion screw from the cap to do the final bleed.
Step 7. With the shock at about a 45° angle, push and hold the shock shaft to the top and insert the
prepared emulsion screw/seal again. Oil will leak out during this process. Tighten the screw until snug
(do not overtighten).
Step
1
Step
2-3
Step
4
Step
5
Step
6-7
We've found it's easiest to complete steps 1 & 2 on each shock before moving on to step 3.
By the time you've finished step 2 on the last shock, the first one will be ready for step 3.
Fill with oil,
Pump up and down
3-5 times,
Then screw on cap
Fill with oil,
Pump up and down
3-5 times,
Then screw on cap
Pump up
and down
30 times
Pump up
and down
30 times
Prepare caps by
inserting seals
AND
Push smaller
screws into seals
Push shaft up
to bleed air out
AND
Insert screw snug
(do not overtighten)
TKR1248 TKR1248
Pull shaft down,
remove screw
AND
Push shaft up to bleed air,
insert screw snug
(do not overtighten)