Test
1.
T
he gas is sent to the gas inlet window while the detector is operating.
2.
Within 10 seconds, the detector switches to alarm mode and starts to emit a beep tone. At the same
time, the green LED goes out and the red LED lights up. In the meantime, the addressable fire alarm
system to which the gas detector is connected turns into an alarm condition. In this case you must reset
the connected system.
3.
The gas alarm intensity is set according to EN-50194-1. When the gas density decreases, the detector
alarm stops and returns to normal state mode.
4.
Frequently gas test carried out at intervals, thereby shortening the life and reduces the sensitivity of the
gas detector.
5.
Detector can be included in the system after it pass the tests.
WHAT TO DO IN THE ALARM CONDITION
Just before the detector goes into an alarm state, you can smell the gas in the environment.
In the case of an alarm sound or the smell of gas in the absence of alarm, the following recommendations
are recommended:
Keep calm and perform the following procedures. No operations required in order:
- All kinds of smoke emitting flame is extinguished,
- All gas devices are switched off,
- No electrical equipment is turned on or off, including the gas detection device,
- The gas supply is switched off from the main gas control and / or from the storage tank (if the LPG source),
- Doors and windows open to increase ventilation,
- No telephone used in the building where gas is suspected to be in the building.
Where appropriate, homes and similar places will be abandoned if the alarm continues to operate even after
the alarm has been re-established and if the cause of the leak is not easily understood and / or cannot be
verified. The tested the installation, the company that provides gas to be secured and made the necessary
repairs and / or a 24-hour emergency gas service is IMMEDIATE NOTIFICATION.
If the alarm has stopped or a lock-out alarm has been established according to the manufacturer's
instructions and the cause of the operation of the alarm has been determined (for example, a gas tap opened
with a non-flammable igniter), the main gas supply can be restored after stopping the gas outlet and closing
all the devices.
Manufacturer and Service Center
*It complies with WEEE regulations. This product is made of high quality parts and materials that can be
recycled and reused. Therefore, do not dispose of the product with domestic or other waste at the end of its
service life. Take it to a collection point for the recycling of electrical and electronic equipment.
*After 5 years of service life as determined and announced in the list of Annexes to After Sales Services
published in the Official Gazette dated 13/6/2014 and numbered 29029.
Important
General
✓
Read this manual carefully before operating the appliance and save it for later use.
✓
TFD-1170 is a fixed device, so you need a circuit breaker in your installation.
✓
Follow all warnings and precautions specified in the manual. Follow all operating and operating instructions,
respectively.
✓
Keep devices away from water and moisture.
Environmental conditions
Do not operate the device in extreme hot and cold environments outside the following conditions.
Temperature: -
10°C
and +55
°C
Humidity:
%95 RH Max.
Information on Faulty Usage
Do not allow the opening or changing the settings on your device by unauthorized persons. As a result of
such a situation, your device can start working differently compared to the first case.
Security check
Request a service from your dealer to check that the device is working properly and safely.
Failure Situations Requiring Service
If a fault occurs or the cases mentioned below, please contact your authorized dealer or reseller.
✓
When the power cord or plug is damaged,
✓
When any liquid flows or the object falls into the device,
✓
When exposed to water or rain,
✓
If the device has been dropped or the case has been damaged
✓
If the device has a noticeable level of performance change,
✓
If the device does not operate normally according to the operating instructions.
Incorrect operations may cause other malfunctions, so call for service.
Cautions and Consumer Care, Repair and Cleaning
-
Do not attempt to repair the device yourself, as this could result in possible electric shock or damage to
the device if you open or tamper with the appliance.
-
If a fault occurs, please contact your dealer or authorized service center. Technical intervention must only
be carried out by qualified service personnel.
-
The device should be cleaned with a damp cloth. Never use chemicals such as spray, polish, detergent.
-
Alcohol, thinner, cologne, sprays, lighter fluid is very intense, pungent cleaning agents do not mislead the
device and can cause false alarms to malfunction of the detector. Also gas detection holes should be dry
and clean.
Transportation & Shipping
The device must be carefully handled so that it is not exposed to any external impact and does not allow any
liquid to enter. Malfunctions resulting from improper transport are not covered by the warranty.
Human Health and Environmental
This device does not contain any chemical or biological substances that may harm human health.
Bilgi Elektronik San. ve Tic. A.Ş.
Dudullu Organize Sanayi Bölgesi 1. Cadde İsmet Tarman İş Merkezi
No:1 Kat:2 No:32 Ümraniye / İstanbul
/ Türkiye
Phone:
+90 216 455 88 46
Fax:
+90 216 455 99 06
TFD-1170
Intelligent Addressable Natural Gas Detector
Installation Manual
Date: 04/01/2021
Rev:01
