Tekmatix TMFM - 65, Руководство по эксплуатации

Страница: 21 / 28

18
Cleaning coffee machine
Before cleaning the interior of the coffee machine, power it
off, and pull out plug. Never immerse the coffee machine in
water. There will be a risk of electric shock.
Regularly check the coffee machine whether there is excessive
coffee powder precipitate inside the machine. You can use a
brush to remove the coffee precipitate.
Use a dry and soft rag to wipe the touch panel of the machine.
As the touch panel is made of glass, please do not hit it to
avoid the risk of electric shock once the glass broken.
Use a dry and soft rag to wipe the surface of the machine,
and never use hard objects to clean coffee leftover on the
surface, otherwise it would cause the surface damaged.
●
●
●
●
Cause s n o it u l o S m e l b o r P
The coffee temperature is too low
.
Coffee only comes out from the
coffee spout drop by drop.
Insufficient coffee oil.
The coffee cup was not pre-heated.
Wash the coffee cup with hot water
before making coffee.
Make some more cups of coffee.
Adjust the grinding wheel to a rough state
or use the suitable coffee powder.
Run the brewing unit washing program.
Use the suitable coffee beans.
Several minutes have passed since the
last time of coffee making , so the
brewing unit and the internal pipes are
already cold.
Over fine coffee powder or coffee
bean has been grounded too fine.
Brewing unit filter was blocked.
Picked the wrong coffee bean type.
Screen always indicates "EMPTY TRAY".
Wipe the sheetmetals to dry ( refer to P16). The sheetmetals at the end of the drip
tray are dirty or wet.
Screen always indicates "INSTALL TRAY".
Clean the coffee grounds in the bottom.
Coffee grounds in the bottom of the
machine are not cleaned.
Screen always indicates “FILL WATER
TANK”, but the water tank is full.
Clean the water tank ( refer to P17).
The water tank inductor is trapped.
Screen always indicates “FILL BEANS”,
but the bean container is full.
1. Stir coffee beans in bean container.
2. Observe if the coffee beans are over
roasted or charcoal roasted.
3. Clean the beans container ( refer to
P17).
The bean container is too oily and
sticky for coffee beans.
“Errors 1 to 7”is displayed.
1. Restart coffee machine.
2. If “errors” still exists, switch off the main
power, and contact with the customer
sevice center.
The coffee machine failures, cannot
continue to be used.
Milk sprays from the milk frother. Reassemble the milk frother.
The milk frother was not assembled
correctly.
The milk frother cannot make any milk
foam.
Cleaning the milk frother ( refer to P17). The milk frother is blocked.
The grinder arising noises.
Make coffee again, if it still failures, please
contact with the
customer sevice
center
.
There are foreign objects in the grinder.
This chapter will instruct you some errors that may encounter
and the solutions.
If there are some failures cannot be resolved by the following
methods, please contact with the customer sevice center.
●
●
Failures handling