3
2
3. Appearance of XU/XV-1000
S/E
Series Radio
4. Monitor Button(M)
5. Menu Button(P)
14. Belt Clip
2. PTT Button
3. Channel
control
8. Speaker
9. Mic Jack
6. Accessory
Connector
1. On/Off/
Volume control
Battery Pack
11. Battery Locker
13. Antenna Connector
10. Emergency Button
(XU/XV-1000
E
Only)
1. On/Off/
Volume control
7. RX/ TX LED
Antenna
1. On/Off/Volume Control
Turns the radio on and off and adjusts
audio volume level.
2. PTT Button(Push-To-Talk Button)
Radio transmission button. It is recommended to
talk 5~10cm away from the micro phone for the
best voice communication.
3. Channel
Control
16 channels are selectable by rotary switch.
4 Monitor Button(M)
The monitor mode is enabled and disabled by
pressing the Monitor button (M) on the side.
Normal Mode : During pressing the Monitor
button(M) for about 2 seconds, it is possible to
check the receiving status.
Continuous Mode : During pressing the Monitor
button(M) for more than 2 seconds, the Radio
will make a “Beep” tone, which means the
monitor function is maintained and if you press
the Monitor button(M) again, the monitor
function will be released.
5. Menu Button(P)
Available to use for scan function.
6. Accessory Connector
The Accessory Connector is used when using an
external speaker microphone or doing PC
programming or making the Cloning or using as a
Repeater.
7. RX /TX Led
This LED is a lamp indicating the current status of
the Radio and please refer to the below contents.
①
RX : Green Lamp.
②
TX : Red Lamp.
③
CTCSS, DCS Error : Green Blinks.
④
Low Battery: Red Blinks with “beep” sound.
8. Speaker :
1W
9. Mic :
It is recommended to talk 5~10cm
away from the mic.
10. Emergency Button
(XU/XV-1000
E
Only)
11. Battery Locker :
This is for separation of
battery.
12. Battery
13. Antenna Connector
14. Belt Clip
3. Basic Operation of XU/XV-1000
S/E
Series Radio
Please read this manual carefully before using XU/XV-1000
S/E
series Radio.
This manual contains important information about using Radio.
figure 3-1) Installation and Removal of the Antenna
▶
3.1 Installation and Removal of the Antenna
When installation of the antenna, giving a strong pressure to the Radio or pulling the antenna with a
strong power from the Radio can make a damage on the antenna connector, which may cause the
Radio to have a critical problem.
▶
3.2 Installation and Removal of the Battery
3.2.1 Installation of the battery
To install battery, slide up the battery towards the top of the
radio until battery latch is locked.
3.2.2 Removing the Battery
- Slide the battery latch located on the bottom of radio to
the open position as shown in figure 3-2.
- The battery is removed by pressing it against and sliding it
towards the bottom of the radio.
Installation of the
Battery
Removing the
Battery
figure 3-2) Installation and
Removal of the Battery
figure 3-3) Installation and Removal of
the Belt Clip
- To attach belt clip to radio, align belt clip rails with the
grooves in radio and slide the belt clip onto the mounting
rails until it latches into place.
- To remove belt clip from radio, push up on tab of belt clip
with flat bladed screwdriver and at the same time, slide
the belt clip towards the top of Radio(figure 3-3).
▶
3.3 Installation and Removal of the Belt Clip
www.Tekk-Radios.com
