Teka TCD70, Инструкция по эксплуатации

Страница: 13 / 16

13 Instruction Manual
9. Troubleshooting
Warning!
Only authorised technicians can carry out repairs.
Before contacting our customer service team, please refer to the table below to see if your
fault can be fixed by yourself. Should a service technician visit be arranged and its found
there are no faults with the appliance, a call out charge will apply.
Problem Solution
Display isn’t turning on. — Check that the mains plug is inserted and switched on
at the power point.
— Check that a programme is selected on the programme
selection dial.
— Check that the relevant fuse hasn’t blown.
indicator is flashing
— Empty the water container as per the steps in 8.3 within
this user manual.
indicator is flashing
— Clean the air cooler.
— Clean lint filter.
Dryer doesn’t start — Check the start button has selected.
— Check the appliance door has closed.
— Check that the programme has been set.
Water is running out of the
dryer — Align dryer horizontally.
— Clear air condenser and door seals.
Door is opening by itself — Press the door door closed until it “clicks” into position.
— Ensure that the dryer hasn’t been overloaded with
clothes.
Humidity within the room is
increased significantly — Ensure the room has adequate ventilation.
— Clean the cool vent grill.
— Ensure that the air condensor has been inserted.
Degree of dryness was not
reached or drying time too
long. — Clean the lint filter and wash the condenser.
— Empty the water container.
— Clean the moisture sensors.
— Try using a higher drying programme next time.
Note:
If the above steps don’t resolve your issue or you cannot resolve the fault by yourself:
— Press the “On/Off” button,
— Switch off the appliance at the power outlet and remove the plug,
— Call our customer service team.
10. Technical Data
Power supply 220-240V ~50Hz
Rated input Power 2000W
Ambient temperature +5°C - + 35°C
Dimensions 595 x 615 x 845 mm
Rated drying capacity 7.0kg
Net Weight 42kg
Note:
— The rated capacity is the maximum capacity of dry clothes. Refer to the Programme table
for maximum loadings specific to each programme.
— Do not install the dryer in a room where there is a risk of a frost occurring. At
temperatures around freezing point, the dryer may not be able to operate properly.
— There is a risk of damage if the condensed water is allowed to freeze in the pump, or
water container.
Troubleshooting