25
GB
Please note:
To do anything with a hotplate, it needs
to be selected. When you want to use a
hotplate, check that the corresponding
luminous point (13) is lit up. If after the
hotplate has been selected you touch
its sensor again, it will be blocked in
the power position that was set (except
on models shown in figure 8).
To turn a hotplate up to full power
quickly:
Once the hotplate has been
selected, touch sensor
(4) once, and
the hotplate will be switched on to full
power.
SWITCHING OFF THE HOTPLATE
1
The hotplate must have already been
selected. The corresponding decimal
point has to be lit.
2
Use sensor
(4) to decrease the power
to level
0
. The hotplate will automatically
switch off.
To turn it off quickly: By touching sensors
and
(4/5) simultaneously, the hot-
plate will be turned off quickly.
RESIDUAL HEAT INDICATOR
On the hotplate's power indicator, a
H
will
appear when the surface of the glass in
this area reaches a temperature at which
there is a risk of burning. When this risk no
longer exists, the indicator light will go out
(if the hob is disconnected), or a
0
will
show if the hob is still connected.
Switch the hotplate off before you have
finished cooking if you wish to take advan-
tage of the residual heat and thus save
electricity.
Please note: If there is a power
cut while the
H
is turned on, and then
the power comes straight back on
again, the residual heat indicators will
not come back on even if the cooking
surfaces are still hot. You should bear
this in mind.
SWITCHING THE APPLIANCE (TC) OFF
The appliance can be switched off at any
time by touching the general on/off sensor
In Standby mode, a
H
will appear in the
areas that are hot. None of the other hot-
plate displays will light up.
Double and triple Circuit Hot-
plates (except on the TS600, TB
600, TR 600 and TT 600)
Double and Triple circuit hotplates offer the
option of using either the inside ring or the
outside rings as well, depending on the size
of the pan.
CONNECTING / TURNING ON THE
DOUBLE AND TRIPLE HOTPLATES
1
The corresponding hotplate has to be
selected - the decimal point (13) has to
be lit up.
2
Select the power you want (between 1
and 9) using sensor
or
(4/5).
3
Touch the double hotplate sensor
(6)
to activate the second ring. When the
pilot (10) comes on, it is in operation.
4
On the model TR 735 AB, if you want to
activate the third ring you may touch the
sensor
(6) again. Then the second
pilot (10) will light.
Models TT 630 and TC 620:
The double circuit may be activated or
deactivated by touching the sensor
(6)
