33
EN
Installation
Important
INSTALLATION AND SETUP SHOULD BE
CARRIED
OUT
BY
AN
AUTHORISED
TECHNICIAN
IN
LINE
WITH
CURRENT
INSTALLATION STANDARDS.
Positioning of the hobs
A gap with the dimensions shown in the figure will
be cut into the worktop or stove.
A
B
C
D
E
570
480
58,5
58,5
163,5 min.
The system for fixing the hob is intended for use
with kitchen units with a thickness of 20, 30 or 40
mm.
In free standing models, a board should be placed
inside the kitchen unit, with the top of the board
being 20 mm. below the bottom of the hob.
The hobs described in this manual can only be
installed with TEKA ovens.
The minimum distance between the surface
supporting the cooking pans and the lower part of
the kitchen unit or the hood located above the hob
should be 600 mm. If the hood’s installation
instructions recommend that the gap is greater
than this, you should follow this advice.
The unit where the hob and oven will be located
will be suitably fixed.
When hobs are handled before being installed,
care should be taken in case there is any
protruding part or sharp edge which could
cause injury.
TEKA assumes no responsibility for any
malfunction or damage caused by faulty
installation.
