POWER CANOPY™
Integral Driver - Solid State LED
Standard Installation
PROJECT:
TYPE:
Phase 1 - Rough In
Installation of Back box
1. Install conduit and junction box (By Others)
to be used with this product.
2. Install junction box so that front face is flush
with finished wall or ceiling.
3. Connect box to conduit and pull wires for
connections (See Wiring diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
• Suitable for through wire.
• Suitable for installation into combustible materials.
• Rated for 90° C.
• Junction box, universal mounting ring screws, box mounting hardware
and gaskets (By Others)
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
RELEASE DATE
9-13-17
REFERENCE
NUMBER
INS-2673-00
WIRING DIAGRAM
Phase 2 - Finish Installation of Fixture with Power Canopy™.
LINE
COM
GROUND
WIRING DIAGRAM
Driver
GROUND FROM FIXTURE
LINE
(+)
Fixture
COM
GROUND
Driver
(-)
GROUND ON PLATE
LINE
COM
4. Mount canopy to wall plate using four (4) #8-32
stainless steel button head screws with 3/32”
Allen wrench. Do not over tighten.
1. Remove one or two wire entrance knockouts on
wall plate. Pull primary branch circuit through
knockout(s). Attach wall plate to junction box
using appropriate hardware (By Others). Seal
plate to wall as per NEC.
2. Ground primary branch circuit to wall plate per
NEC. Make watertight connections from driver
to primary branch circuit using waterproof wire
connectors. (By Others)
See wiring diagram.
3. Connect fixture to driver with provided quick
disconnect.
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.tekaillumination.com • [email protected]
