IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
DATE
5-3-18
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.tekaillumination.com • [email protected]
REFERENCE NUMBER
INS-2523-00
HIGH LIGHT WALL™ (HLW)
Phase 1 - Rough In
Installation of Back box
1. Install Conduit (By Others) to be used with
this product.
2. Install junction box so that front face is flush
with finished wall. Seal building envelope as
per NEC.
3. Connect box to conduit and pull wires for
connections (See wiring diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
• Suitable for through wire.
• Suitable for installation into combustible materials.
• Rated for 90° C.
• Junction box, universal mounting ring screws, box mounting hardware
and gaskets (By Others)
LINE
12V
FIXTURE
COM
WIRING DIAGRAM
Remote
Magnetic
Transformer
COM
WIRING DIAGRAM
2. Make watertight connections from remote
transformer to fixture leads using waterproof wire
connectors (By Others).
See wiring diagram.
1. Loosen locking ring set screw using a 5/64” Allen
wrench. Slide locking ring and canopy cover
forward on stem to expose mounting plate.
4. Slide locking ring and canopy cover back until
mounting plate is covered.
3. Place wiring and connections into junction
box. Mount plate with mounting hardware
(By Others) to junction box.
Seal building
envelope as per NEC. Do not overtighten.
Phase 2 - Fixture Installation
5. Tighten set screw on locking ring using a 5/64”
Allen wrench.
LED - For use with 12VAC
remote
transformer or magnetic transformers
only. TEKA Illumination cannot guarantee
performance with third party manufacturers’
transformers.
Decorative Canopy Installation Instructions
