User instructions
10
•
Do not use table salt, as it contains insoluble substances which,
over time, may damage the water softening system.
•
The salt container should be refilled before starting the wash
program. This way, the excess saline solution will be immediately
removed by the water; prolonged presence of salt water inside the
tank may lead to corrosion.
Be careful not to confuse the salt and detergent packages; adding
detergent to the salt container will damage the water softening system.
ADDITIONAL FUNCTIONS
(customizing the consumer parameters)
(available in all programs except the soak program)
The dishwasher is equipped with an electronic device for adjusting the
water softening setting according to the hardness of the water.
To adjust the water softening setting, proceed as follows.
•
Keep the PROGRAM DELAY button (6) pressed for a few seconds,
until the H- symbol, followed by the set value, appears on the
3-FIGURE DISPLAY (8);
•
The PROGRAM DELAY button (6) can be pressed again to select
the most suitable hardness value (H1, H2 …H5). Refer to the “Water
hardness table” to select the value;
•
To exit the programming mode press the START/PAUSE button (4)
or do not touch the keypad for 2 seconds to allow the system to exit
the mode automatically.
