IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
RELEASE DATE
5-3-18
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.tekaillumination.com • [email protected]
REFERENCE NUMBER
INS-2588-00
Installation of Fixture
Phase 1 - Rough In
Installation of Back box
1. Install Conduit (By Others) to be used with
this product.
2. Install junction box so that front face is flush
with finished ceiling. Seal building envelope
as per NEC.
3. Connect box to conduit and pull wires for
connections (See wiring diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
• Suitable for through wire.
• Suitable for installation into combustible materials.
• Rated for 90° C.
• Junction box, universal mounting ring screws, box mounting hardware
and gaskets (By Others)
Use heavy-duty pendant adapter if luminaire weight exceeds 50 lbs.
Junction box must be secured to a structural member suitable for
weight of the luminaire and other weight likely to be placed upon it.
WIRING DIAGRAM
3. Secure canopy plate to junction box with
two (2) #6-32 Phillips screws using Phillips
screwdriver.
Seal building envelope as per
NEC. Do not overtighten.
4. Slide decorative canopy cover up stem into
place and secure to mounting plate by hand-
tightening provided two (2) decorative cover
nuts.
1. Hand loosen then remove two (2) decorative
cover nuts, then slide decorative canopy down
stem to expose mounting plate.
LINE
FIXTURE
COM
GROUND
LINE
COM
GROUND
2. Make watertight connections from primary
branch circuit wiring to fixture leads using
waterproof wire connectors (By Others).
Connect green fixture wire to green incoming
ground wire. See wiring diagram.
BEACON STEM MOUNT™ (BSM)
