IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
DATE
2-8-17
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.tekaillumination.com • [email protected]
REFERENCE NUMBER
INS-2566-00
APOLLO PILLAR™ (APL)
Phase 1 - Rough In
Installation of Back box
1. Install Conduit (By Others) to be used with
this product.
2. Install junction box (By Others) so that front
face is flush with finished wall.
3. Connect box to conduit and pull wires for
connections (See wiring diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
• Use 4” round cast box
• Suitable for through wire
• Suitable for installation into combustible materials.
• Rated for 90° C.
• Junction box, universal mounting ring screws, box mounting hardware
and gaskets (By Others)
3. Place connections inside junction box, then
attach base plate assembly to junction box
using mounting hardware (By Others).
5. Slide fixture assembly over mounted base plate
assembly. Lock in place with two (2) 1/4-20 1/2”
socket stainless steel cone point set screws
using a 1/8” Allen wrench. Ensure fixture is
completely seated.
2. Connect primary branch circuit wiring to fixture
leads using watertight wire connectors (By
Others) as per NEC. Connect green fixture wire
to green supply wire. See wiring diagram.
1. Loosen two (2) 1/4-20 1/2” socket stainless steel
cone point set screws using a 1/8” Allen wrench. Lift
fixture assembly from base plate assembly.
WIRING DIAGRAM
LINE
FIXTURE
COM
GROUND
LINE
COM
GROUND
Phase 2 - Fixture Installation
4. Place a bead of silicone-based sealant (By Others)
around the mounted plate to create a watertight seal.
Seal any unused hole(s) in mounting plate.
APL Series not intended for base down mounting.
Junction box must be secured to a structural member suitable for
weight of the luminaire and other weight likely to be placed upon it.
APL Series not intended for base down
mounting.