Preparation for Use
2-8
10 TEGAM WAY ● GENEVA, OHIO 44041 ● 440
-
466
-
6100 ● FAX 440
-
466
-
6110 ●
connection to the instrument.
3.
The instrument
will immediately display a temperature measurement
for the
connected channels. However, to ensure
valid and best accuracy measurements,
continue to Step 4
below;
4.
Set the desired measurement parameters as follows:
a.
Enter the Setup Menu by pressing
, hold the key down for
approximately 1.5 seconds, and then release
it;
b.
The active thermocouple
t
ype is flashing on the
display
. Use
to
select
the
thermocouple type
of the connected temperature probe
(E, J,
K, T, B, N, R, or S);
c.
Momentarily (do not hold) press
to save your selection
and move to
the next parameter
;
d.
The active temperature unit is flashing on the display
. Use
to
select the desired temperature unit (°C, °F, or K);
e.
Momentarily press
to save your selection and move to the next
parameter;
f.
Channel 1 probe offset value is flashing on the display. If the
temperature probe’s offset value is known, press
to set the
Channel 1 probe offset to the probe’s offset value. See
Section 3.10,
for more information
.
g.
Momentarily press
to save your selection and move to Channel 2
probe offset (if equipped);
h.
If desired, repeat Step (f) above for Channel 2;
i.
Momentarily press
to save your selection and exit the setup
menu
.
Congratulations! You’r
e
now ready to make accurate and reliable temperature
measurements, wherever and whenever you may need to.
We know you are eager to begin using your new thermometer, but this overview is just the
beginning. Please take a moment to familiarize yourself with this Operation Manual to learn
about all the features and benefits of your new TEGAM Thermocouple
Thermometer.