ENG
washer. Scouring powders and
scouring pads are not recom-
mended.
Note : if food has burned, leave
the cooking dish to soak a little
while before cleaning.
• NEVER IMMERSE THE
APPLIANCE WITH HEATING
ELEMENT AND CORD IN
WATER.
• Unplug and leave the appliance to cool.
• The body of the appliance and the fixed reflector
can be cleaned with a sponge and washing-up liquid.
Avoid using an abrasive scouring pad.
N.B. : to easily clean the fixed reflector, raise the lif-
table heating element.
• The heating element does not require cleaning, but
when cold, it can be rubbed with a dry cloth to remove
any food deposits.
• The cooking dish, the lid, grill plate and the drip
tray (depending on model) must be cleaned after
each use with normal washing-up liquid or in a dish-
0
1
2
3
4
stop
keep warm /
re-heat
simmer
fry
seal
(some accessories are supplied
depending on model)
USE OF ADJUSTABLE THERMOSTAT
CLEANING
So that the appliance does not take too much place in
your cupboard, we advise you to stock the different
accessories as indicated on the following drawing :
STORING THE APPLIANCE
Note : You can adjust the thermostat depending on the dishes to be cooked. With smaller quan-
tities of food, it may be necessary to reduce the thermostat to a lower number.
WIRING INSTRUCTIONS
WARNING : ALL APPLIANCES MUST BE EARTHED.
IMPORTANT : the wires in this lead are coloured in accordance
with the following codes.
Green and Yellow : Earth
Blue : Neutral
Brown : Live
Connect the Green/Yellow wire to the ter-
minal in the plug marked “E” (or by the
earth symbol) or coloured Green and
Yellow.
Connect the Brown wire to the terminal in
the plug marked “L” or coloured Red.
Connect the Blue wire to the terminal in
the plug marked “N” or coloured Black.
Seek professional advice if you are unsure of the correct procedure
for the above.
ABOUT YOUR FACTORY FITTED PLUG
The cord is already fitted with a plug incorporating an appro-
priate fuse. If the plug does not fit your socket outlet, see para-
graph below. Should you need to replace the fuse in the plug
N: Blue
or black
E: Green and
yellow or green
L: Brown
or red
Fit correct
fuse(13 amp)
Use cable
gripper
supplied, an appropriately rated
approved BS 1362 fuse must be used
(refer to electrical specification for
fuse rating).
If the plug supplied does not fit your
socket outlet, it should be removed
from the mains lead and disposed of
safely. The flexible cord insulation
should be stripped back as appropria-
te and a suitable alternative plug fit-
ted. The replacement plug must be
equipped with an appropriate fuse. If
the plug has external access to the
fuse (non-rewirable type plug) please
note that the fuse cover is an impor-
tant part of the plug. Please ensure
that it is always refitted correctly. If
you lose this cover, please do not use
the plug. You may contact Tefal U.K.
Limited for a replacement.
FOR U.K. USERS ONLY :
ADDITIONAL INFORMATION AND INSTRUCTIONS
Содержание Astucio
Страница 1: ...R...
