Before Beginning
Before reading further, study the drawing below to familiarize yourself with the important components
of your new Teeter Hang Ups inversion table.
Table Bed
A-Frame
Main Shaft
Ankle Locking Pin
Ankle Comfort Dial
Handle
Feet
Rear and Front
Ankle Clamps
Tether Strap
Crossbar
Step Six
Insert the Main Shaft (NX-1600) into the
Table Bed (NX-1300)
• Ensure that the A-frame is fully open and
locked at the Spreader Arms.
• Rotate the Table Bed into its use position
(Figure 15).
• Loosen the Main Shaft De-rattler Knob at
the base of the Main Shaft Housing.
• With the height adjustment settings on the
Main Shaft facing up, insert the end of the
Main Shaft into the Main Shaft Housing at
the base of the Table Bed.
• Pull out the Height Selector Locking Pin to
allow the Main Shaft to slide in further, then
release the pin to engage a hole. (Refer
to the Owner’s Manual for proper height
adjustment before use.)
Note: The De-rattler Knob is an optional
feature that prevents a slight shift
when you invert. Product security is not
compromised if you choose to not tighten
the knob.
• The Main Shaft must rest against the
Crossbar of the A-frame (Figure 16). The
Crossbar prevents the table from rotating
forward when the user steps on the Foot
Platform. If the Main Shaft does not rest
on the Crossbar as shown in Figure 16
then the Table Bed has been assembled
backwards onto the A-frame and this must
be corrected before use.
Rotation Adjustment Arm
Crossbrace
3
Teeter Hang Ups • NXT-R
Teeter Hang Ups • NXT-R
8
ASSEMBLY
PRE-ASSEMBLY
1
De-Rattler Knob
2
Main Shaft Housing
3
Height-Selector Locking Pin
Figure 15
Figure 16
3
1
2
1
1
Main Shaft properly resting on Crossbar.
