8/5/2019
teenage engineering – oplab module guide
https://teenage.engineering/guides/op-z/modules/oplab
2/5
interface
ratings
connectors
cv / gate out: 3X control
voltages and 1X gate
(note on / off) for analog
synthesizers. midi in /
out: standard midi 3.5
mini jack input and
included.
lock switch
before placing the
module the lock switch
should be open. by
closing the lock switch it
activates the module and
locks it in place.
modes for
out / in
left switch selects
outgoing signals: midi,
trig or pocket operator.
right switch selects
incoming signals: midi
or trig.
installing
1
2
3
4
-90° X4
to help prevent
malfunctions and / or
damage to speakers or
other devices, be sure to
turn off the OP
–
Z before
inserting the module.
rotate each of the four
yellow rubber bumpons on
the back side of the OP
–
Z
90 degrees counter
clockwise.
remove the backplate of
OP-Z using the tool found
inside your OP-Z, or a lego
shaft. be firm but careful.
remove the dummy module.
break the lego legs and use
them as a screwdriver for
the next time you open
your OP-Z.
5
6
7
done
!
CV out:
voltage range: 0 to +5V
CV 2 / 3 out:
voltage range: -5 to +5V
gate out:
voltage range: 0 to +5V
midi out:
voltage range: 0 to +5V
trig out:
voltage range 0 to +5V
po out:
voltage range 0 to +5V
midi in:
voltage range: -10 to +10V
trig in:
voltage range: -10 to +10V
note: maximum ratings indicate
limits beyond which damage may
occur. always make sure to check
the voltage levels of external
equipment before connecting it to
the oplab module. all outputs are
short-circuit tolerant.
