4
Teel Operating Instructions and Parts Manual
4RJ19, 4RJ20, 4RJ21, 4RJ22 and 4RJ23
Teel Residential
Submersible Sump Pumps
®
E
N
G
L
I
S
H
Maintenance
TO CLEAN/REPLACE IMPELLER
Hazardous voltage.
Can shock, burn, or
kill. Before removing pump from pit for
service, always disconnect electrical
power to pump and control switch.
Risk of electric
shock. Do not
handle pump with wet hands or when
standing on wet or damp surfaces.
1. Unplug cord from power source.
2. Remove pump from pit.
Electrical shock
hazard. Do not lift
pump by power cord. Use lifting ring or
handle for all lifting and lowering of
pump.
3. Remove baffle plate.
4. Remove lower pump body screws
and separate lower pump body
from upper pump body.
5. Hold shaft with screwdriver in slot
in end of shaft. Unscrew impeller
counter clockwise from shaft.
NOTE:
Impeller on Model 4RJ23 is not
removable. Clean in place and go to
Step 8.
6. Clean or replace impeller.
7. Thread the clean or new impeller
onto the shaft. Hold shaft with
screwdriver and tighten impeller
firmly hand tight.
8. Remount lower pump body.
9. Reinstall baffle plate.
10. Reinstall pump in pit
11. Plug in unit.
12. Test pump before operating by
filling sump and running pump
through one complete cycle.
Flood hazard.
Failure to make
this operational check may lead to
improper operation, premature failure,
and flooding.
FLOAT SWITCH REPLACEMENT
Remove faulty switch and replace as
indicated in “Float Switch Installation”,
on Page 3.
Limited Warranty
DAYTON ONE-YEAR LIMITED WARRANTY.
Teel
®
residential submersible sump pump, Models covered in this manual, are
warranted by Dayton Electric Mfg. Co. (Dayton) to the original user against defects in workmanship or materials under normal use
for one year after date of purchase. Any part which is determined to be defective in material or workmanship and returned to an
authorized service location, as Dayton designates, shipping costs prepaid, will be, as the exclusive remedy, repaired or replaced at
Dayton’s option. For limited warranty claim procedures, see PROMPT DISPOSITION below. This limited warranty gives purchasers
specific legal rights which vary from jurisdiction to jurisdiction.
LIMITATION OF LIABILITY.
To the extent allowable under applicable law, Dayton’s liability for consequential and incidental
damages is expressly disclaimed. Dayton’s liability in all events is limited to and shall not exceed the purchase price paid.
WARRANTY DISCLAIMER.
Dayton has made a diligent effort to provide product information and illustrate the products in this
literature accurately; however, such information and illustrations are for the sole purpose of identification, and do not express or
imply a warranty that the products are MERCHANTABLE, or FIT FOR A PARTICULAR PURPOSE, or that the products will necessarily
conform to the illustrations or descriptions.
Except as provided below, no warranty or affirmation of fact, expressed or implied, other than as stated in the “LIMITED
WARRANTY” above is made or authorized by Dayton.
PRODUCT SUITABILITY.
Many jurisdictions have codes and regulations governing sales, construction, installation, and/or use of
products for certain purposes, which may vary from those in neighboring areas. While Dayton attempts to assure that its products
comply with such codes, it cannot guarantee compliance, and cannot be responsible for how the product is installed or used. Before
purchase and use of a product, review the product applications, and all applicable national and local codes and regulations, and be
sure that the product, installation, and use will comply with them.
Certain aspects of disclaimers are not applicable to consumer products; e.g., (a) some jurisdictions do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you; (b) also, some
jurisdictions do not allow a limitation on how long an implied warranty lasts, consequently the above limitation may not apply to
you; and (c) by law, during the period of this Limited Warranty, any implied warranties of implied merchantability or fitness for a
particular purpose applicable to consumer products purchased by consumers, may not be excluded or otherwise disclaimed.
PROMPT DISPOSITION.
Dayton will make a good faith effort for prompt correction or other adjustment with respect to any
product which proves to be defective within limited warranty. For any product believed to be defective within limited warranty,
first write or call dealer from whom the product was purchased. Dealer will give additional directions. If unable to resolve
satisfactorily, write to Dayton at address below, giving dealer’s name, address, date, and number of dealer’s invoice, and describing
the nature of the defect. Title and risk of loss pass to buyer on delivery to common carrier. If product was damaged in transit to
you, file claim with carrier.
Manufactured for Dayton Electric Mfg. Co., 5959 W. Howard St., Niles, Illinois 60714 U.S.A.
