Page 10
Four-Cycle Engine • Horizontal Crankshaft • Air-Cooled
181-1032-14
VI. Stopping Your Engine and
Short-Term Storage
Stop engine according to equipment manufacturer’s
instructions.
To avoid unsupervised operation of
an engine, especially by children,
NEVER leave it unattended when it is running. Always turn
off the engine after use and remove ignition key, if
provided.
NEVER store the engine with fuel in
the fuel tank inside a building with
potential sources of ignition such as hot water and space
heaters, clothes dryers, electric motors, etc.
VII. Maintenance
An adult should perform maintenance
on this engine. Only allow children to
perform maintenance if an adult has determined they are
experienced and capable of such operation.
To prevent accidental starting when working on equipment,
always:
• Disconnect spark plug wire and keep it away from
spark plug. See "G. Avoid Accidental Starts"
instructions on page 2.
• Keep the disconnected spark plug wire
securely away from metal parts where arcing
could occur.
• Attach the spark plug wire to the grounding
post, if provided.
• Disconnect battery at negative terminal first, if
engine is equipped with an electric starter.
• Turn off all engine switches.
• Remove ignition key, if provided.
A. Checking and Changing Oil
To avoid engine damage, it is important to:
• Check oil level before each use and after every
5 operating hours when engine is warm.
See "A. Checking Oil Level" instructions on page 4.
• Change oil after first 2 operating hours and every 25
operating hours thereafter; more often if operated in
extremely dusty or dirty conditions. Engine should
still be warm but not hot from recent use.
1.
Be sure you find the correct drain plug location, if
provided. See Figure 22.
2.
Disconnect spark plug wire and keep it away from
spark plug. See "G. Avoid Accidental Starts" instruc-
tions on page 2.
• Keep the disconnected spark plug wire securely
away from metal parts where arcing could occur.
• Attach the spark plug wire to the grounding post, if
provided.
3.
Be sure the gas cap is on and is tightened securely.
4.
Clean area around oil drain plug. See Figure 21.
5.
Place approved recyclable oil container
under oil drain plug, tipping engine to
position the oil drain plug at the lowest
point on the engine. (See equipment
manufacturer’s instructions).
6.
Remove oil drain plug and drain oil into approved con-
tainer. See Figure 21.
NOTE
Used oil must be disposed of at a proper collection center.
7.
Install oil drain plug and tighten securely.
8.
Fill with recommended oil. See "III. Oil and Fuel Speci-
fications" instructions on page 3. See Table 1, on page
3. See Figure 22.
9.
Wipe away any spilled oil.
10. Carefully disconnect spark plug wire from grounding
post, if provided.
11. Carefully re-connect spark plug wire to spark plug.
!
WARNING
!
WARNING
!
WARNING
Figure 21. Possible Oil Drain Plug Locations
Figure 22. Possible Oil Fill Locations
