Tecumseh LV148SA, Руководство оператора

Страница: 14 / 24

Page 12 Four-Cycle Engine • Vertical Crankshaft • Air-Cooled 181-1270-14
B. Extended Storage
I. Draining Fuel
NOTES
Clean debris from engine before draining fuel from
carburetor. See "I. Clean Engine" instructions on page 11.
If you have prepared your fuel for short term storage it is not
necessary to drain fuel that contains stabilizer from your
carburetor. See "A. Short Term/Seasonal Storage"
instructions on page 11.
To avoid severe injury or death,
DO NOT pour fuel from engine or
siphon fuel by mouth.
1. To prevent serious injury from fuel fires, empty fuel tank
by running engine until it stops from lack of fuel. DO
NOT attempt to pour fuel from engine.
2. Run the engine while waiting until the remaining fuel is
consumed.
NEVER leave the engine
unattended when it is running and
NEVER run engine in enclosed areas.
3. Begin servicing the cylinder bore. See "II. Oil Cylinder
Bore" instructions.
II. Oil Cylinder Bore
When lubricating cylinder bore, fuel
may spray from spark plug hole. To
prevent serious injury from fuel fires, follow these
instructions:
1. Disconnect spark plug wire and keep it away from
spark plug. See Figures 24 and 25.
• Keep the disconnected spark plug wire
securely away from metal parts where arcing
could occur.
• Attach the spark plug wire to the grounding
post, if provided.
• Disconnect battery at negative terminal first, if
engine is equipped with an electric starter.
• Turn off all engine switches.
2. Remove ignition key, if provided. Remove spark plug.
3. Squirt 1oz. (30ml) of clean engine oil into spark plug
hole.
4. Cover spark plug hole with rag to prevent fuel from
spraying from spark plug hole when starter rope is
pulled.
NOTES
For engines equipped with recoil starters proceed to Step 5.
For engines equipped with electric starters proceed to Step
6.
5. Grasp starter cord handle and pull out slowly using a
full arm stroke. Repeat once. (This will distribute oil
throughout the cylinder to prevent corrosion during
storage.)
6. Install spark plug.
7. Carefully disconnect spark plug wire from grounding
post, if provided.
NOTE
Connect spark plug wire before attempting to start engine.
III. Oil
Change oil if not changed within the last 3 months. See
"A. Checking and Changing Oil" instructions on page 9.
IV. Battery
See equipment manufacturer’s instructions for proper
battery storage, if present.
V. Clean Engine
Remove any snow, ice or slush from exterior of engine.
!
WARNING
!
WARNING
!
WARNING
Figure 24. Disconnecting/Connecting Spark Plug
Figure 25. Spark Plug Connection
1. Grounding Post
2. Spark Plug Wire
3. Spark Plug
2
1
3