9
TTG240-300-360
TROUBLE SHOOTING
CAUSES AND REMEDIES
The fan is powered, but the impeller does not
turn.
Remove the power supply and check that: the power connectors
are properly inserted into their home, the connection wires are
tight, there are no obvious signs of burns on the connectors.
The fan runs very slow or too fast.
Check the value of the power, using a multimeter, and check the
correspondence of the values with those reported on the
identification label of the product purchased.
If the problem persists, contact the TECSYSTEM technical department.
The impeller is stuck and cause the fan
failure.
The critical environmental conditions
can
anticipate
the
deterioration of the mechanical parts. Proper planning of cleaning,
maintenance and the installation of the VRT control series will allow
you to lengthen significantly the efficiency of the fan.
WARRANTY CONDITIONS
The Product purchased is covered by the manufacturer's or seller's warranty at the terms and conditions set forth in the
"Tecsystem s.r.l's General Conditions of Sale", available at www.tecsystem.it and / or in the purchase agreement.
The warranty is considered valid only when the product is damaged by causes attributable to TECSYSTEM srl, such as
manufacturing or components defects.
The warranty is invalid if the Product proves to have been tampered with / modified, incorrectly connected, because of
voltages outside the limits, non-compliance with the assembly and use technical data, as described in this instruction
manual.
The warranty is always ex Corsico as stated in the "General Conditions of Sale".
TECHNICAL INFORMATION: [email protected]
COMMERCIAL INFORMATION: [email protected]
USEFUL CONTACTS
EQUIPMENT DISPOSAL
European directives 2012/19/EC (WEEE) and 2011/65/EC (RoHS) have been approved to reduce electrical and elec-
tronic waste and promote the recycling and reuse of the materials and components of said equipment, cutting down on
the disposal of the residues and harmful components of electrical and electronic materials.
All the electrical and electronic equipment supplied after 13 August 2005 is marked with this symbol, pursuant
to European directive 2002/96/EEC on electrical and electronic waste (WEEE). Any electrical or electronic
equipment marked with this symbol must be disposed of separately from normal domestic waste.
Returning used electrical devices: contact TECSYSTEM or your TECSYSTEM agent for information on the correct dis-
posal of the devices.
TECSYSTEM is aware of the impact its products have on the environment and asks its customers active support in the
correct and environmentally-friendly disposal of its devices.
