TECshow NAVIGATOR SPLIT 8, Руководство пользователя, Страница: 12 / 26

P. 12
Tecshow Navigator Split 8 |
No Response to DMX
Response: Suspect the DMX cable or connectors,
a controller malfunction, a light effect DMX card
malfunction.
1. Check the DMX setting. Make sure that DMX
addresses are correct.
2. Check the DMX cable: Unplug the unit; change
the DMX cable; then reconnect to electrical
power. Try your DMX control again.
3. Determine whether the controller or light effect
is at fault. Does the controller operate properly
with other DMX products ? If not, take the con -
troller in for repair. If so, take the DMX cable and
the light effect to a qualified technician.
Symptom Solution(s)
Applies to
Lights Foggers
& Snow
Controllers Dimmers
& Chaser
Auto shut off Check fan thermal switch reset.
■
Beam is very dim
or not bright at all
Clean the optical system or replace a lamp. Check
the 220/110V switch for proper setting.
■
Breaker/Fuse
keeps blowing
Check the total load placed on the device.
■
Chase is too slow Check the user manual for speed adjustment.
■ ■ ■
Device has no
power
Check the mains power supply. Check the fuse.
(internal and/or external)
■ ■ ■
Fixture is not
responding
Check the DMX settings for correct addressing.
Check all connected DMX cables. Check the polarity
switch settings.
■
Fixture is on, but
there is no sound -
controlled move -
ment.
Make sure you have the correct audio mode on
the control switches. If audio provided via ¼” jack,
make sure a live audio signal exists. Adjust the
sound sensitivity control.
■ ■ ■
Fixtures reset
correctly, but all
respond erratically
or not at all to the
controller.
-The controller is not connected; please reconnect.
-3-pin XLR Out of the controller does not match
XLR Out of the first fixture on the link (i.e. signal is
reversed). Install a phase reversing cable between
the controller and the first fixture on the link.
- One of the fixtures is defective and disturbs data
transmission on the link. Bypass one fixture at a
time until normal operation is regained: unplug
both connectors and connect them directly togeth -
er Have the defective fixture serviced by a qualified
technician.
■
Lamps cuts off
sporadically
Possible bad lamp or the fixture is overheating.
Lamp may be at the end of its life.
■
English version