TECshow HALO 740 XL, Руководство пользователя

Страница: 11 / 37

P. 11
- Tecshow Halo 740 XL
English Version
split to a `Y` cable. DMX 512 is a very high-speed
signal. Inadequate or damaged cables, soldered
joints or corroded connectors can easily distort
the signal and shut down the system.
4. The DMX output and input connectors are pass-
through to maintain the DMX circuit, when one
of the units’ power is disconnected.
5. Each lighting unit needs to have an address set
to receive the data sent by the controller. The
address number is between 0-511 (usually 0 & 1
are equal to 1).
6. The end of the DMX 512 system should be termi-
nated to reduce signal errors.
7. 3 pin XLR connectors are more popular than 5
pin XLR.
• 3 pin XLR: Pin 1: GND, Pin 2: Negative signal
(-), Pin 3: Positive signal (+)
• 5 pin XLR: Pin 1: GND, Pin 2: Negative sig-
nal (-), Pin 3: Positive signal (+), Pin 4/Pin 5:
Not used.
DMX 512 Configuration
11CH MODE (MODE 1):
Address Setting
If you use a universal DMX controller to control the
units, you have to set DMX address from 1 to 512 so
that the units can receive DMX signal.
Press MENU button to enter menu mode, select DMX
Functions, press the ENTER button to confirm, use
the UP/DOWN button to select DMX Address, press
the ENTER button to confirm, the present address
will blink on the display, use the UP/DOWN button
to adjust the address from 001 to 512, and press the
ENTER button to store. Press the MENU button back
to the last menu or let the unit idle 7 seconds to exit
menu mode.
Please refer to the following diagram to address
your DMX512 channel for the first 4 units:
Channel mode Unit 1 Address Unit 2 Address Unit 3 Address Unit 4 Address
11 channels
1 12 33 44
15 channels 1 16 31 46
14 channels
1 15 29 43
CHANNEL VALUE FUNCTION
1
PAN
000 – 255 0° - 540°
2
TILT
000 – 255 0° - 220°
3
000 – 255 PAN/TILT SPEED
Fast - Slow
4
SHUTTER:
000 – 019 Off
020 – 024 Open
025 – 064 Strobe: Fast - Slow
065 – 069 Open
070 – 084 Pulse, fast close slow open