Important Safety Precautions
It is recommended that you plug the chiller into an
RCD plug at all times. Do not operate SeaChill chillers
or any accessory to SeaChill chillers (heater or UV
sterilizer) without water flow. Overheating of lamp or
heater may occur.
After installation, monitor unit for at least an hour to
confirm there are no leaks.
To avoid potential electric shock, care should be taken since
aquarium equipment involves use of electricity and water. For
each of the following situations, do not attempt repairs by
yourself; return the appliance to an authorized service facility
for service or discard the appliance:
1.
Unplug chiller from wall outlet before installation of
Heater. Only plug chiller in when directed to by the
installation instructions.
2.
If electrical components of the chiller or Heater get
wet do not plug in until thoroughly dried
3.
Examine the Heater closely after installation. Do not
plug in if there is water on parts not intended to be
wet.
4.
Do not operate chiller or Heater if it has a damaged
cord or plug, or if it is malfunctioning or damaged in
any manner.
5.
Close supervision is necessary when any appliance is
used by or near children.
6.
Always unplug the chiller from an outlet when before
putting on or taking off parts, and before cleaning.
Never yank cord to pull plug from outlet. Grasp the
plug and pull to disconnect.
7.
Do not use the Heater for other than intended use.
The use of attachments not recommended or sold
by the Heater manufacturer may cause an unsafe
condition.
8.
Do not install or store the Heater where it will be
exposed to the weather or to temperatures below
freezing.
9.
Make sure the Heater is properly installed before use.
10.
If an extension cable is necessary, use a cable with a
proper rating, or the chiller may overheat. Care
should be taken to arrange the cable so that it will
not be tripped over or pulled.
KEEP THESE INSTRUCTIONS
