Step 2 Apply Power to the Drive
• Apply AC power to the Drive and observe Operator. LCD Display Line 1 should read “Freq.
Cmd 0.00Hz”. Line 2 should read “TECO”.
STOP Key should have RED LED lit. Drive LED and FWD LED’s will be lit.
Step 3 Set Drive to Run Mode
• If Red Drive LED is not on with AC power up, PressPGRM/DRIVE key until Red Drive LED is on.
Inverter is now in the Run Mode.
Step 4 Check Motor Rotation Without Load
• Check LCD display to verify that line 1 displays Frequency Command “Freq. Cmd 0.00Hz”. (If not
displayed, press DISPLkey repeatedly until “Freq. Cmd X.XX Hz” is displayed.)
• Change frequency to low rotation speed (5Hz suggested) to check motor rotation. Observe
flashing numeric character after Cmd. This character can be changed by pressing the up or down
Arrow keys. To move right or pressing the up or down Arrow keys. left for next digit, press RESET
key. Enter desired frequency up to 5Hz. Press the DATAENTER key to set the speed. (Numbers will
stop flashing.)
• Press RUN key (Red LED should light) and check motor rotation. If it is not correct:
Press STOP key.
Remove AC power.
Wait for LED “charge” lamp to extinguish.
Reverse motor leads T1 and T2.
Restart the drive and check new rotation.
• Press STOP key to stop the drive.
Step 5 Check Full Speed at 60Hz
• Repeat Step 4 by setting frequency to 60Hz.
• Press RUN key. Check drive acceleration to full speed.
• Press STOPkey to stop drive and check deceleration.
Step 6 Other Operations
• For information, see MA7200 InstruPlease refer to the following pages:
Set Accel ........................................ p.36
Set Decel ..................................... p. 36
Set Max Speed ........................... p. 44
Set Min Speed ............................ p. 44
Set Motor Rated Current ........ p. 44
iv
PA 7300
INSTRUCTION MANUAL
