ATTENTION
If your PA7300 does not start properly...
1. Review this
Quick Start Guide
or the
Instruction Manual
2. Visit our website:
http://www.tecowestinghouse.com
3. Call for factory support:
1-800-451-8798 (ask for Drive technical support)
Quick Start Guide
This guide is to assist in installing and running the inverter to verify that the drive and motor are working properly.
Starting, stopping and speed control will be from the keypad. If your application requires external control or
special system programming, consult the PA7300 Instruction Manual supplied with your inverter.
Step 1 Before Starting the Inverter
• Please review Safe Operation Notes (page 1) of the PA7300 Instruction Manual. Verify drive was installed
in accordance with the procedures as described in PA7300 Handling Description on pages 3 through
17. If you feel this was improper, do not start the drive until qualified personnel have corrected the
situation. (Failure to do so could result in serious injury).
• Check inverter and motor nameplates to determine that they have
the same HPand voltage ratings. (Ensure that full load motor amps
do not exceed that of the inverter.) Remove the terminal cover to
expose the motor and power terminals. a. Verify that AC power is
wired to L1, L2, and L3 (pages 11 & 12). b. Verify that Motor leads
are connected to T1, T2, and T3 (pages 11 & 12). (The two leads may
need to be reversed if motor rotation is not correct.
Refer to pages 14-17).
iii
PA 7300
INSTRUCTION MANUAL
names and functions shown as below:
RUN
STOP
PRGM
DRIVE
DSPL
EDIT
ENTER
DIGITAL OPERATOR JNEP-31
DRIVE FWD REV REMOTE
SEQ
REF
FWD
REV
JOG
RESET
operation mode indicators
DRIVE : lit when in DRIVE mode
FWD
: lit when there is a forward run command input
REV
: lit when there is a reverse run command input
SEQ
: lit when the run command is enabled from the control
circuit terminal or RS-485 option card (REMOTE mode)
REF
: lit when the frequency reference from the control
circuit terminals (VIN or AIN) or RS-485 option card
enabled (REMOTE mode)
LCD Display
English Display: 2 row, each row has 20 characters at most
Keys (Key functions are defined in Table 11)
RUN
STOP
PRGM
DRIVE
DSPL
EDIT
ENTER
DIGITAL OPERATOR JNEP-31
DRIVE FWD REV REMOTE
SEQ
REF
FWD
REV
JOG
RESET
operation mode indicators
DRIVE : lit when in DRIVE mode
FWD
: lit when there is a forward run command input
REV
: lit when there is a reverse run command input
SEQ
: lit when the run command is enabled from the control
circuit terminal or RS-485 option card (REMOTE mode)
REF
: lit when the frequency reference from the control
circuit terminals (VIN or AIN) or RS-485 option card
enabled (REMOTE mode)
LED Display
5 digitals 7-degment LED.
Keys (Key functions are defined in Table 11)
32
32
33
JOG
(L/R)
JOG
(L/R)
